Every amp you've ever wanted. 20 pounds.
A 200-watt tube combo weighs 60–80 lbs, costs $2,000+, gives you one sound, and needs new tubes every couple of years. The Aviator Mach 3 Combo delivers 200 watts through a Celestion Copperback 12" at 20 pounds — with two channels, twelve voices, built-in reverb and tremolo, and zero maintenance. Carry it in one hand. Set it down. Play every gig you'll ever have.
Two fully independent channels — each with six voices that reach deep into the history of vintage amplifiers. Set up Channel 1 for sparkling Fender cleans and Channel 2 for cranked Marshall crunch. Footswitch between them mid-song. Or flip the selector to center and run both channels simultaneously — layering two voices into something no single amp has ever done. Two inputs mean you can even plug in two instruments and switch between them on the fly.
The Celestion Copperback is a 250-watt 12" speaker purpose-matched to the Mach 3's power section. It handles everything the amp can throw at it — clean headroom at full power, smooth breakup at low volumes, and a balanced frequency response that doesn't favor one voice over another. This isn't a generic speaker bolted into a cabinet. It's an engineered pairing.
The Distortion Boost adds breakup before the Voice and EQ section — just like putting a drive pedal in front of the amp. Every voice gets a second personality. Clean shimmer becomes edge-of-breakup grit. Smooth warmth becomes full-bore roar. Twelve voices become twenty-four usable sounds without touching a pedalboard.
The Limiter control sets the ceiling on how far into overdrive the sound can go. Crank the gain for sustain, but keep the limiter dialed to prevent it from getting harsh. You ride the edge of breakup without falling over it. This is how session players build tone that sounds cranked on the record but stays controlled in the room.
Built-in Reverb and Tremolo — both footswitch defeatable — mean fewer pedals on your board. The 3-band active EQ with Bass, Mid, and Treble gives you real tonal sculpting, not passive roll-offs.
Here's what separates the Mach 3 on a professional stage: separate SPKR VOL and SIG OUT controls. Set your SIG OUT level with your sound engineer once, and it stays locked — then use SPKR VOL to adjust your on-stage monitor level without changing the front-of-house feed. No more "turn down" arguments. No more inconsistent mixes.
FX Loop for your pedalboard. Cab Sim for direct recording. Headphone output via SIG OUT for silent practice. Add an extension speaker via the 4-ohm jack and the amp splits power between both cabinets automatically. The head is removable from the combo if you ever want to pair it with a different cab. Universal voltage runs on any power grid on earth.
Power Output: 200 watts of variable tube-like solid-state power.
Weight: ~20 lbs (9 kg) for the combo setup; the internal head unit unbolts easily if you want to run it separately.
Speaker: 12-inch Celestion Copperback speaker.
Channels & Voices: Two independent channels with 6 selectable vintage/modern amp models per channel (can be run separately or blended).
Onboard Effects: Lush reverb and tremolo with tap/footswitch options.
I/O & Controls: Active 3-band EQ, effects loop, headphone jack, and a balanced direct/signal out with cab simulation for PA or recording
Warranty & Returns
All New products are covered by the manufacturers new warranty. Please check their website for the length of warranty and warranty conditions. If an item you receive is faulty get in touch with us ASAP. Second Hand products come with a 4 week warranty from us. If there is an issue let us know ASAP! This covers normal use and does not cover accidental damage, misuse, wrong power plugged into it, modding, water damage or any other damage caused by mistreatment. Just treat it nice and all will be good!
Shipping
We send A LOT of packages every week so don't worry about the shipping side of things!
We've never lost a thing and your awesome new gear will be packed up really well to avoid any damage in transit.
If your order comes in before 2pm we will ship it same day. Most of the time we pack things up all the way to 4pm so just call if you need it to leave same day after 2pm.
We ship mainly with Australia Post but may use a courier depending on location and size of the package.
Free Post ships with Australia Post standard and expected shipping times are between 4-6 business days depending on location. It will be longer to outside of metro and rural areas.
Express Post will usually be with you next business day in metro areas of QLD, NSW, SA, VIC and TAS. WA will take 2 days to metro and extra days after that to out side metro and rural areas.
Everything we ship has a tracking number with the exception of some power cables and smaller envelope packages. You will be emailed tracking once your order has been shipped!
Videos
Every amp you've ever wanted. 20 pounds.
A 200-watt tube combo weighs 60–80 lbs, costs $2,000+, gives you one sound, and needs new tubes every couple of years. The Aviator Mach 3 Combo delivers 200 watts through a Celestion Copperback 12" at 20 pounds — with two channels, twelve voices, built-in reverb and tremolo, and zero maintenance. Carry it in one hand. Set it down. Play every gig you'll ever have.
Two fully independent channels — each with six voices that reach deep into the history of vintage amplifiers. Set up Channel 1 for sparkling Fender cleans and Channel 2 for cranked Marshall crunch. Footswitch between them mid-song. Or flip the selector to center and run both channels simultaneously — layering two voices into something no single amp has ever done. Two inputs mean you can even plug in two instruments and switch between them on the fly.
The Celestion Copperback is a 250-watt 12" speaker purpose-matched to the Mach 3's power section. It handles everything the amp can throw at it — clean headroom at full power, smooth breakup at low volumes, and a balanced frequency response that doesn't favor one voice over another. This isn't a generic speaker bolted into a cabinet. It's an engineered pairing.
The Distortion Boost adds breakup before the Voice and EQ section — just like putting a drive pedal in front of the amp. Every voice gets a second personality. Clean shimmer becomes edge-of-breakup grit. Smooth warmth becomes full-bore roar. Twelve voices become twenty-four usable sounds without touching a pedalboard.
The Limiter control sets the ceiling on how far into overdrive the sound can go. Crank the gain for sustain, but keep the limiter dialed to prevent it from getting harsh. You ride the edge of breakup without falling over it. This is how session players build tone that sounds cranked on the record but stays controlled in the room.
Built-in Reverb and Tremolo — both footswitch defeatable — mean fewer pedals on your board. The 3-band active EQ with Bass, Mid, and Treble gives you real tonal sculpting, not passive roll-offs.
Here's what separates the Mach 3 on a professional stage: separate SPKR VOL and SIG OUT controls. Set your SIG OUT level with your sound engineer once, and it stays locked — then use SPKR VOL to adjust your on-stage monitor level without changing the front-of-house feed. No more "turn down" arguments. No more inconsistent mixes.
FX Loop for your pedalboard. Cab Sim for direct recording. Headphone output via SIG OUT for silent practice. Add an extension speaker via the 4-ohm jack and the amp splits power between both cabinets automatically. The head is removable from the combo if you ever want to pair it with a different cab. Universal voltage runs on any power grid on earth.
Power Output: 200 watts of variable tube-like solid-state power.
Weight: ~20 lbs (9 kg) for the combo setup; the internal head unit unbolts easily if you want to run it separately.
Speaker: 12-inch Celestion Copperback speaker.
Channels & Voices: Two independent channels with 6 selectable vintage/modern amp models per channel (can be run separately or blended).
Onboard Effects: Lush reverb and tremolo with tap/footswitch options.
I/O & Controls: Active 3-band EQ, effects loop, headphone jack, and a balanced direct/signal out with cab simulation for PA or recording
Warranty & Returns
All New products are covered by the manufacturers new warranty. Please check their website for the length of warranty and warranty conditions. If an item you receive is faulty get in touch with us ASAP. Second Hand products come with a 4 week warranty from us. If there is an issue let us know ASAP! This covers normal use and does not cover accidental damage, misuse, wrong power plugged into it, modding, water damage or any other damage caused by mistreatment. Just treat it nice and all will be good!
Shipping
We send A LOT of packages every week so don't worry about the shipping side of things!
We've never lost a thing and your awesome new gear will be packed up really well to avoid any damage in transit.
If your order comes in before 2pm we will ship it same day. Most of the time we pack things up all the way to 4pm so just call if you need it to leave same day after 2pm.
We ship mainly with Australia Post but may use a courier depending on location and size of the package.
Free Post ships with Australia Post standard and expected shipping times are between 4-6 business days depending on location. It will be longer to outside of metro and rural areas.
Express Post will usually be with you next business day in metro areas of QLD, NSW, SA, VIC and TAS. WA will take 2 days to metro and extra days after that to out side metro and rural areas.
Everything we ship has a tracking number with the exception of some power cables and smaller envelope packages. You will be emailed tracking once your order has been shipped!
Related Products
-
Milkman SoundIn Stock$1,339.00US Purveyors of classy vintage tone Milkman have unveiled an incredible unit that packs heaps of genuine valve-powered sound into a pedal-sized un...
View full details$1,339.00 -
Victory AmplificationIn Stock$1,849.00The Duchess is a powerful, ultra compact amplifier. It has four valves in the front end, 180-watt power section, reverb and tremolo. Now it has be...
View full details$1,849.00 -
Victory AmplificationIn Stock$1,849.00The all-rounder of the Victory V4 amp range, the Jack is the amp we developed with ‘Guthrie Govan’. Four valves in the front end, 180-watt power s...
View full details$1,849.00
